【基本性能】
承印物：
冷確2小時后進行性能【使用說明】

1、網 板：250—350目聚脂絲網印版
2、膠 刮：建議使用70-85度聚氨酯膠刮
3、參考用量：250 目網板印刷約為30㎡/㎏
4、選用溶劑：719快干水，718中干水，783慢干水，因印刷環境溫度、通用量及印刷圖案大小不同進行適當選擇
5、網板清洗：選用有機溶劑清洗（如：洗網水）

 

【固化劑】

 

【干燥條件】

 

 

【產品包裝】

  1公斤裝、5公斤裝、20公斤

【保 質 期】

  5℃—25℃條件下可存放兩年，避免強光照射、防接觸強酸、強堿。

【注意事項】
1、市場上材料具有多樣性，請先進行性能測試再批量印刷。
2、酒精測試、附著力測試、耐磨擦測試等其他測試需等油墨完全干燥后方可進行。
3、油墨，稀釋劑使用及儲存時嚴禁煙火。使用時注意施工場所的通風狀況良好。
4、盡量避免皮膚直接接觸，對本品過敏者，使用前應涂覆一層皮膚扶膚膏或戴不滲透手套。
5、本品不慎濺入口、鼻、眼、耳內，應用大量水清洗或直接求助醫生。

[basic performance]
Printed matter:
Performance after 2 hours [instructions]
1, net board: 250 - 350 mesh polyester screen plate
2. Scraping: it is recommended to use 70-85 degrees of polyurethane scraping
3, dosage: 250 mesh screen printing is about 30 kg / square meters
4: 719, selection of solvent drying water, dry water, 783 dry slowly in 718, due to the environmental temperature, and the amount of general printing printing patterns of different sizes were chosen
5, net plate cleaning: use organic solvent cleaning (such as: washing water)

[curing agent]


[drying condition]


[product packaging]
1 kilograms, 5 kilograms, 20 kilos
[shelf life]
It can be stored for two years at 5 - 25 - C to avoid strong light, contact strong acid and strong alkali.

[cautions]
1, the material in the market is diverse, please test the performance first and then print it in batch.
2. Other tests, such as alcohol test, adhesion test, abrasion resistance test, etc., need to be done after the ink is completely dry.
3. Ink, the use and storage of diluents strictly prohibit fireworks. When used, pay attention to the ventilation condition of the construction site.
4, try to avoid direct skin contact. For those allergic to this product, a layer of skin creams or wearing gloves should be coated before use.
5, this product is inadvertently splashed in the entrance, nose, eye and ear, and uses a lot of water to clean or direct to the doctor.
[本信息來自于今日推薦網]